In the case of an optical fibre transmission link, LEDs and LASERs are used as
- A.Detectors
- B.Sources
- C.Repeaters
- D.Amplifiers
Correct answer
Explanation
The correct answer is B, sources. At the transmitting end of a fibre link the electrical signal must be turned into light, and the two devices that do it are the light-emitting diode and the laser diode. The light-emitting diode is cheap, long-lived and spreads its light over a range of wavelengths, so it suits short multi-mode links; the laser diode gives a narrow, coherent beam that couples into a thin single-mode core and so suits long high-speed routes. Option A, detectors, is the job of the photodiode at the far end, which turns the arriving light back into current. Option C, repeaters, describes a complete unit placed along a long route to receive, clean and resend the signal; a laser may sit inside one, but a repeater is not what the diode itself is called. Option D, amplifiers, strengthen a signal, and in fibre that work is done by an erbium-doped fibre amplifier, not by the source.
Read the full article: Data Communication and Transmission Media: Notes
Practice Questions
View allThe material used for making optic-fibre cable in general is
- A.Copper
- B.Aluminium
- C.Steel
- D.Transparent plastic
Show answer
An optical fibre carries information as pulses of light, not as an electric current, so its core and cladding must be transparent and not conducting.
Read the full explanation →Five channels each with 100 kHz bandwidth are to be multiplexed together. What is the minimum bandwidth of the link, if there is a need for a guard band of 10 kHz between the channels to prevent interference?
- A.500 kHz
- B.540 kHz
- C.460 kHz
- D.560 kHz
Show answer
In frequency division multiplexing each channel is given its own slice of the frequency band, and a small unused strip called a guard band is left between two neighbouring channels so that one does not spill into the next.
Read the full explanation →An optical fibre transmits light along its length on the principle of
- A.Diffraction
- B.Total internal reflection
- C.Polarisation
- D.Dispersion
Show answer
The fibre has a core of higher refractive index surrounded by a cladding of lower refractive index. Light that enters the core and meets the boundary at an angle greater than the critical angle is reflected entirely back into the core, with none of it refracted away into the cladding.
Read the full explanation →Which transmission medium is completely immune to electromagnetic interference?
- A.Unshielded twisted pair
- B.Coaxial cable
- C.Optical fibre
- D.Radio waves
Show answer
Electromagnetic interference acts on moving charge, so any medium that carries a signal as an electric current can pick up noise from motors, fluorescent lamps, lightning and nearby cables.
Read the full explanation →A walkie-talkie is an example of which mode of data transmission?
- A.Simplex
- B.Half-duplex
- C.Full-duplex
- D.Parallel
Show answer
A walkie-talkie allows both parties to speak and both to listen, so communication is two-way, but the set has a single push-to-talk switch and one person must release it before the other can be heard.
Read the full explanation →