The reciprocal of the bulk modulus of a material is known as its
- A.Compressibility
- B.Rigidity
- C.Ductility
- D.Tenacity
Correct answer
Explanation
The correct answer is A, compressibility. The bulk modulus measures how strongly a substance resists a change in volume under uniform pressure, so its reciprocal measures how readily the volume yields, and that quantity is called compressibility. Gases, which are squeezed easily, have a very small bulk modulus and therefore a very large compressibility, while liquids and solids have the opposite. Option B is wrong because rigidity refers to the shear modulus, the resistance to a sliding or twisting deformation, which is a separate quantity. Option C is wrong because ductility is the ability of a material to be drawn into a wire, a property of its plastic range rather than a reciprocal of any modulus. Option D is wrong because tenacity refers to the tensile strength of a material. Remember also that the bulk modulus alone is defined for all three states of matter.
Read the full article: Elasticity, Stress, Strain and Hooke's Law: Exam Notes
Practice Questions
View allHooke's law states that within the elastic limit
- A.Stress is directly proportional to strain
- B.Stress is inversely proportional to strain
- C.Strain is independent of stress
- D.Stress is proportional to the square of the strain
Show answer
Hooke found that so long as a body is not strained beyond its elastic limit, the restoring force per unit area rises in step with the fractional deformation, and the constant ratio of the two is called the modulus of elasticity.
Read the full explanation →The SI unit of stress is the
- A.Newton
- B.Joule
- C.Pascal
- D.Watt
Show answer
Stress is the restoring force divided by the area over which it acts, so its unit is the newton per square metre, and that combination is given the special name pascal, the same unit used for pressure.
Read the full explanation →Strain is a quantity that has
- A.The unit newton per square metre
- B.No unit and no dimensions
- C.The unit metre
- D.The same unit as energy
Show answer
Strain is defined as the change in a dimension divided by the original value of the same dimension, a length divided by a length or a volume divided by a volume, so the units cancel and only a pure number survives.
Read the full explanation →The ratio of longitudinal stress to longitudinal strain within the elastic limit is called
- A.Bulk modulus
- B.Modulus of rigidity
- C.Young's modulus
- D.Poisson's ratio
Show answer
It governs the stretching or compression of a wire or rod along its length and is obtained by dividing the force per unit area of cross section by the fractional change in length.
Read the full explanation →Which of the following statements about steel and rubber is correct in physics?
- A.Rubber is more elastic because it stretches more
- B.Steel is more elastic because its modulus of elasticity is much larger
- C.Both have equal elasticity
- D.Neither is elastic, since both are solids
Show answer
Elasticity in physics is not the ability to stretch far but the strength of the restoring tendency, measured by the stress needed to produce a given strain, and steel demands an enormously greater stress than rubber for the same fractional extension.
Read the full explanation →